Dodge Dart Forum banner

Injen Intake install

9.7K views 25 replies 12 participants last post by  mopar382  
#1 ·
Does anyone have a copy of the instructions they could scan in or a link to them already online.

I'm a reasonably intelligent guy that can follow directions pretty well, but I took a look at the stock air box and the mess of crap hoses/fittings has me trying to figure out if I want to tackle an intake.

Somebody hook a brotha up please.

:cool2:
 
#3 ·
^^don't have it yet, pretty sure I can figure it out but would like to see the directions first. As many people on here have them surely somebody could scan it in and post it or email it to me.
 
#7 ·
I installed this intake today in 15 min. without the instructions. it's a very simple install if your gonna run just the short ram.
all guys that running this intake, do you have a loud whistle when you go wide open throttle? it almost sounds like a huge boost leak. I never heard an intake sound like that. I let my buddy take for a spin and I could hear it whistle a few hundred feet away.
 
#8 ·
I was wondering the same thing bout the whistling noise. Mine makes the same noise and I have it setup as the full CAI.
 
#14 ·
^^If you can scan them I can host & post for myself and any future dart owners that would benefit from it.
 
#16 ·
I can scanned them in the morning! I just got my intake tonight in the mail. I'll be installing it tomorrow so I'll just scan the instructions for you tomorrow
 
#18 ·
Image


Image


Image


Image
 
#22 ·
Just installed my intake and lets just say it took me a couple of hours to do it!! I decided to do it without taking off the bumper. I must have done or followed the instructions wrong because I couldn't take or find the retaining clip from the radiator splash guard. I spent maybe an hour on just trying to find it. I decided to just cup the cloth or whatever kind of material it is in the lower intake tube. I was able to take off all the cloth but after that it only took me about 30 minutes to put it back together and instal the full cold air intake. It sounds amazing and its pretty loud. I'll be posting some pictures later on my thread if you want to check them out. Good luck with your install once you decide to install the intake.
 
#25 ·
You don't need to pull the front bumper cover off, just the passenger wheel and wheel well liner. Also remove the top radiator shroud by pulling the 8 push pins.

This first photo shows the attachments for the resonator.
The red arrow shows the bolt that is under the radiator top shroud, the location of this bolt is shown in pic #2.
The yellow arrow in pic #1 shows the push pin that is in a hard to see location, but is not that bad to pull.
The green arrow in pic #1 shows the only other attachment for the resonator. By wiggling the assembley & pulling down, it comes right off.
Now you are ready to pull the wheel and liner to pull this resonator out from the car.

This last pic shows the push pins that are attached to the frame mounted bracket and the air filter box.

The front mount stud for the bracket has tape covering the threads to keep from chaffing the wire harness.
The air box is pretty simple to remove and once the push pins and bolts are removed you just need to wiggle and pull up on the air box to remove the box from the bracket.
That just leaves the bracket to be removed.
 

Attachments

#26 ·
Thanks man, really appeciate it. Took me hrs to figure it out. That damn think wouldn't come off. The last push pins where u mark them red on ur pic were holding it in plus it had like a bolt or clip Idk anymore. Got wasted last night afterwards bc it was a pain in the ass ripping it off.