[goonsquadinc8990]

So I know the basics of this general installation but I'm wondering if anyone has any experience wiring one in for one of our darts. I have a 2013 Dodge Dart SE with Injen CAI, MPx Strut Bar, MPx Lightweight Crank Pulley, and Madness GoPedal. I don't have much experience with these newer electrical systems so basically my question is, if you have done this, where is the best place to run the wiring, wire directly to a coil pack? I know you run power (Red+) to the ignition switch, (Black) to ground, (Yellow) to the headlight switch, and (Green) is my sending signal wire. Just need a little guidance on putting this into actual practice please. Thanks a heap. - Leo Santana

 

[alpinegreenneon]

There's already a tachometer on your cluster. Dart electronics are all CANbus and finding direct wiring routes may cause errors because of how it's multiplexed.