Does any know or had success removing the CTM from the Proxy using AlfaOBD? Mine is causing all kinds of issues (and does not work) and I’m having proxy misalignment issues almost daily. Can I use alfaOBD to change the config so it does not include the CTM and realign the proxy without it? Can this be done without unplugging the CTM or would it be best to unplug it? If so, can this be done without taking the dash apart? Thanks.
Badohm
I don't think the configuration sequence for the PROXI can be changed. You might be able to reach under the dash to try to disconnect the connector but that might not stop the BCM from looking for it.
Practice taking a dash apart at a self serve junkyard first. Buy a new CTM, take your dash apart and your problems should be over.
Practice taking a dash apart at a self serve junkyard first. Buy a new CTM, take your dash apart and your problems should be over.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
