Dodge Dart Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter #1
I finally decided to get off my butt and replace the rack and pinion in my car. Today I removed most of the parts to gain access to the module. Tomorrow hopefully I can get the new piece put in early enough to start replacing the shifter bushings on the inside.
I still have to order a new flywheel and have it and the clutch installed but hey I started right!
 

·
Registered
Joined
·
14 Posts
Which part exactly is the module. I recently replaced my R&P with a refurbed unit, but the module isn’t syncing. I still have the old R&P so I was just going to swap the module itself. Just want to make sure I swap the right part
 

·
Super Moderator
Joined
·
3,657 Posts
Which part exactly is the module. I recently replaced my R&P with a refurbed unit, but the module isn’t syncing. I still have the old R&P so I was just going to swap the module itself. Just want to make sure I swap the right part
See my reply in your other post about this.
 
1 - 4 of 4 Posts
Top