Dodge Dart Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
So I’m having problems with my 2013 Dodge Dart Rallye whenever I try to like give it gas and take off it almost acts like there’s a misfire but no codes and when I just drive it without pushing it it’s fine but I’ve cleaned my coil pack connectors and I replaced my spark plugs and tried treating my gas to see if maybe it could be something in there but nothing seems to help
 

·
Super Moderator
Joined
·
3,387 Posts
Do a compression test. It seems to take a lot of misfiring to set a code. If the compression checks out good, replace the coils. They are prone to failing on the 1.4s.
 

·
Registered
Joined
·
799 Posts
I had an issue with my 1.4 having a intermittent mis, it wasn't tripping the CEL so I hooked up my OBDLink scanner to the car and went into the Mode 6 data, and went down to the cylinders and seen one had a few misfires on it. That particular cylinder was still running an OEM coil, so I replaced the coil and the issue was resolved.
 
1 - 4 of 4 Posts
Top