Dodge Dart Forum banner

[HOW-TO] Turn off Hill Assist on Dodge Dart

17033 Views 36 Replies 17 Participants Last post by  ArmyOfDartness
- Symptom/Vehicle Issue: Hill Start Assist Disable Procedure
- Discussion: Request to disable the Hill Start Assist, procedure to complete.
- Hill Start Assist disable procedure (if desired) - Note vehicle roll back mitigation will not be present with this feature disabled.

- Hill Start assist can be disabled if desired. This procedure applies to vehicles equipped with a manual or automatic transmission -
  • Wheels must be pointed straight ahead, on a level surface.
  • Automatic transmission should be in Park.
  • Place manual transmission in neutral if equipped.
  • Begin with the ignition off.
  • Engage park brake,
  • Start engine and wait for ESC OFF lamp to turn off.
  • Apply brake pedal.
  • Turn steering wheel 200 degrees counter clockwise (just over half a turn from center position) Press the "ESC off " button 4 times.
  • Rotate the steering wheel back to center and continue in a clockwise direction until 200 degrees past center.
  • Turn the ignition to off position.
- If procedure was done correctly , ESC malfunction lamp will flash -
1 - 20 of 37 Posts
Perfect topic to wiki! I'm going to turn mine off today because I stalled the car last week and it activated and I wasn't "prepared" for the long brake hold.....
Wait....can this only be done with the limited or am I a n00b?? I don't see a ESC light or physical ESC button....assistance?
My question on this is......how to re-enable if wanted again?
My question on this is......how to re-enable if wanted again?
Well I know the answer to that. The same procedure will re-enable the feature.
Thought it was one of those too easy to be true scenarios lol
  • Like
Reactions: 1
Wait....can this only be done with the limited or am I a n00b?? I don't see a ESC light or physical ESC button....assistance?
Any help or answers to my question above?? ^^^
Any help or answers to my question above?? ^^^
I believe it's next to the hazard button.
I believe it's next to the hazard button.
I thought that was the traction control on/off switch but I'll look this morning.
I thought that was the traction control on/off switch but I'll look this morning.
Yup, you're correct Ryan
Check out your owners manual. It has in there what ESC stands for. Electronic Stability Control, which would be your traction control.
Check out your owners manual. It has in there what ESC stands for. Electronic Stability Control, which would be your traction control.
Well I'll be damned. I'm gonna try that! I guess this is a "RTFM" Ryan...I know I know...I've just been working hard and forgot! Thanks ill try it again.
WHOOHOO! Problem solved. No more stupid hill assist!
Good to know it works. Gonna have to do this myself
The DDCT must not have it, as my car absolutely rolls back on hills.

Though, my build sheet says BNGS - Hill Start Assist
The DDCT must not have it, as my car absolutely rolls back on hills.

Though, my build sheet says BNGS - Hill Start Assist
You're not missing out.....
It's not so much that I feel I'm missing out, just wondering if there is something wrong with my car.
It's not so much that I feel I'm missing out, just wondering if there is something wrong with my car.
Maybe you need a bigger hill? or have you tried to activate it? I read that if you repeat these steps you can turn it back on if you decide you want it again.
1 - 20 of 37 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top