Dodge Dart Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
429 Posts
Discussion Starter #1
Been MIA forever. Long story short, anyone remember fitment on DRP pipes? Trying to clamp it back after it magically popped off after 4 years. Doesn’t seem to fit past the stock inlet on the intercooler. Tightening the clamp down just seems to want to push the coupler further away off the inlet. This is the clamp DRP originally gave. Should I just go with a not as wide clamp? Almost like the clamp is too wide for the plastic inlet. Or see if I can swap the coupler to get past the lip and tighten down after it? My memory is shot, sorry :D
 
1 - 2 of 2 Posts
Top