Are you replacing the correct sensor? Oil temp sensor is on the block and oil pressure sensor is on the head. You should be checking if the signal is shorted to voltage or to the 5 volt circuit as well as checking if the ground is open.
Hope you used a Mopar oem sensor and not part store made in china junk.

 

Can anybody tell me or send me a picture of the blue plug on the control module. The two bottom wires broke off and I don't know which wire goes where. Thank you

 

You did not specify model year and wire colors might be different. See the Mopar connector site and scroll down to your model year:

Mopar Connection Repair Kit

connectorrepairkit.mopar.com

This is for 2016.

 

The wiring schematic:

For the pinout of the connector, go to the Mopar connector site:

Mopar Connection Repair Kit

connectorrepairkit.mopar.com

Under select year scroll down to your model year
Under Select Platform scroll down to PF : DODGE DART
Scroll down to any connector you are looking for

 

Head unit wiring schematic for 2016 Dodge Dart SXT?

 

Page 2 of this thread. If you use the search tool, you will find answers.

 

@alpinegreenneon Do you happen to have diagrams like this for 2013 HVAC?

 

 

This has been posted many times.

 

You can also look at this link:

Mopar Connection Repair Kit

connectorrepairkit.mopar.com

 

I have a 2014 dodge dart 2.4l that does not crank and doesnt have the correct voltage in the exterior fuse box for the starter relay have any diagrams of exterior fuse box or what could i try thank you

 

I have a 2014 dodge dart that does not crank and doesnt have the correct voltage in the exterior fuse box for the starter relay have any diagrams of exterior fuse box or what could i try thank you

Darts can have 3 possible engines, 1.4, 2.0, or 2.4. Always include which engine you have..

 

Sorry 2.4l

 

 

I am looking for the start and run circuits for a 2013 dart with 1.4

 

T-09, T-14, and T-20 are the relays in the PDC.