Also I would be interested in trading my dual exhaust lower valance for a single exhaust lower valance also have the muffler back that would go with it let me know!!

 

View attachment 45457 View attachment 45458

i am going with the @Vino exhaust sometime this summer

 

whos dart is this?? and how do i get my hands on that rearend.. i would definetly buy it, that center exhaust is so dope. But i like the rear diffuser i have .... unless somebody has a center cut rear diffuser like on the srt8 jeeps... i need that in my life.

 

Yeah that's what I'm lookin to do just different tips I'm not to fond of the round ones...not that they don't look good but I found a set of tips off of a 2015srt8 challenger that I'm gonna try if it would let me upload the picture ide post it but I guess I can't do it on my phone

 

I've had my dual tips for my center exhaust for about 2 months now, gotta get the pipes ordered yet.
Once it warms up about April, this will be my next mod. Too cold to lay on the ground building and welding it all together.

Here's a couple pics of the center duals I built on my SRT4 Caliber.

 

like this?

 

like this? View attachment 45473

I would like to see more of a rear ground level shot of this. It looks like you just went under the diffuser without cutting it out. How low is it now?

 

Yeah that's ex what I got planned but I'm gonna be using a set of tips off a 2015 srt8 challenger

 

Nice that looks awsome did that header wrap help at all with heat on the floor? And yeah I hear us on the cold but as long as it stays dry out and not raining or snowing I'm gonna give it a shot ... I can't wait

 

It didn't help with the heat that much, I just did it to hide some ugly welding. I had just bought one of the flux core wire welders and was a little rusty on my welding, it had been almost 16 years since the last time I had welded anything. I'm getting a little better again now so hopefully I won't have to wrap the Dart's exhaust when I'm done with it.

 

Centered exhaust is a nice touch

 

One pipe straight back = more performance too with larger diameter for the turbo

 

Ok so Im gonna be taking the stock rallye rear diffuser off next weekend I have the muffler and tailpipes along with rear diffuser and tips all in good condition make me an offer I live in bucks county pa

 

Ok so this is basically gonna be my setup exept probably not gonna use the muffler due to the space

 

Another shot

 

Im looking to do this on my dart but instead of having the dual tips center right under the rear valance im going to tey to see if i can just run them theough the valance but i would have to cut out a clean exit on the valance .... was wondering if maybe you were trying to do the same and how complicated is it to do? If i run the centered pipes straight back will there be anything in the way that would need me to bend pipes?