Dodge Dart Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
2015 Dodge Dart replaced engine 2.0 with one from junk yard. Engine came with wire harness. But there is no starter wire to start it, a yellow one. What do I do?
 

·
Super Moderator
Joined
·
4,728 Posts
127935
 

·
Super Moderator
Joined
·
4,728 Posts
Can't you use your original harness?
Pics would help.
 

·
Registered
Joined
·
10 Posts
Discussion Starter · #5 ·
Please help I tried running wire from start up to relay. Now it’s in limp mode
 

·
Super Moderator
Joined
·
4,728 Posts
Codes?
 

·
Registered
Joined
·
10 Posts
Discussion Starter · #9 ·
Also before when I turned on key gauges would go over and back now they don’t
 

·
Super Moderator
Joined
·
4,728 Posts
That code has the word circuit which means a wiring or connector problem. There are two cam sensors on the 2.0 engine. Sensor 2 is the intake cam sensor which is mounted on the rear of the engine.

28 - DTC-Based Diagnostics / MODULE, Powertrain Control (PCM), 2.0L / Diagnosis and Testing
127939

P0365-CAMSHAFT POSITION SENSOR CIRCUIT - BANK 1 SENSOR 2

When Monitored and Set Conditions

When Monitored:

•This diagnostic runs continuously with the engine cranking and with the engine running.

Set Conditions:

•At least five seconds or 2.5 engine revolutions have elapsed with Crankshaft Position Sensor signals present but no camshaft position sensor signal.

Default Actions:

•The MIL light will illuminate.

Possible Causes

5-VOLT SUPPLY CIRCUIT SHORTED TO VOLTAGE
5-VOLT SUPPLY CIRCUIT OPEN
5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND
5-VOLT SUPPLY CIRCUIT SHORTED TO THE SENSOR GROUND CIRCUIT
CMP SENSOR SIGNAL 1/2 CIRCUIT SHORTED TO VOLTAGE
CMP SENSOR SIGNAL 1/2 CIRCUIT SHORTED GROUND
CMP SENSOR SIGNAL 1/2 CIRCUIT SHORTED TO THE SENSOR GROUND
CMP SENSOR SIGNAL 1/2 CIRCUIT OPEN/HIGH RESISTANCE
SENSOR GROUND CIRCUIT OPEN/HIGH RESISTANCE
CAMSHAFT POSITION SENSOR 1/2
TONE WHEEL LOOSE OR DAMAGED
POWERTRAIN CONTROL MODULE (PCM)
 
1 - 11 of 11 Posts
Top